Automation and Controlling
a) Relay Selection and Connection.
b) Magnetic Contactor Selection and Connection.
c) Timer Selection and Connection.
d) DOL Starter Circuit.
e) Star- Delta Circuit.
f) Phase Failure Circuit.
g) Limit Switch Operation.
h) Temperature Control Operation.
i) ATS Controlling.
j) RTD, RTC, Operation.
k) Programmable Temperature Controller with PID Operation.
l) Sequence Control Circuit.
m) Motor Safety and Selection Procedure.
n) Water pumps Controlling Circuit.
o) Safety Protection Controlling Circuit by using Limit Switch.
p) Proximity Sensor.
q) Photo Sensor.
r) Motor Forward/Reverse Circuit.
Substation and Industrial wiring
a) Cable Selection.
b) Breaker Selection.
c) Bus-Bar Calculation.
d) LT/HT/PFI Wiring and equipment selection.
e) Floor Plan Procedure.
f) Transformer Selection and Testing Procedure.
g) Transformer Manufacturing.
h) 11KV Sub-Station Installation Procedure.
i) 33/11KV Outdoor Sub-Station equipment selection.
j) CT, PT, VCB Selection.
k) Outdoor Sub-Station Arrangement Procedure.
l) Mesh Earthing Procedure.
m) Relay Co-ordination procedure.
n) Meager Testing procedure.
o) Earth Testing Procedure.
p) ACCORD, ALLIANCE, COMPLAIANCE Issue.
q) Panel Manufacturing and Safety Procedure.
Industrial Automation by PLC:
a) Introduction to PLC.
b) Electric Diagram forming procedure.
c) Convert procedure from Electrical Diagram into
Ladder Diagram.
d) Ladder logic Concept.
e) Number System, Logic gate & Boolean equation. f) Time Operation of PLC.
g) Counter Operation of PLC.
h) PLC wiring procedure/ power connection procedure. i) Load control using PLC, Switch & Sensor.
j) Star Delta Operation with PLC. k) Sequence control with PLC.
l) Inverter speed control with PLC. m) Analog operation of PLC.
n) Auto Transfer Switch (ATS)
o) Door Control.
p) Smart heat chamber controlling. q) Air Conditioner Controlling.
s) Traffic Controlling.
t) Human Machine Interface.
Industrial VFD/Inverter Programming:
a) Basic Theory and Application.
b) Various Types of parameter setting and their operation mode.
c) Analog Operation.
d) Maintenance and Troubleshooting.
AutoCAD Electrical:
a) 2D. b) 3D.
c) Animation.
d) BNBC & NFPA Standard.
e) Panel Drawing.
Diploma (Only for Industrial Training)
All Course Package – 8000 TK Only